Connecting the Stereo
Use the illustrations below to connect your
stereo.
If you want to connect any optional
components to the stereo, see "Connecting
Optional Equipment" in Chapter 7.
STEP 1
Connecting the
Front Speakers
1 Twist the speaker cable coating and pull
it from the end of the cable.
2 Connect the right speaker to (FRONT*)
SPEAKER R connectors and the left
speaker to (FRONT*) SPEAKER L
connectors with the red cord to + and
the black cord to –.
red
black
Connect this portion
* LBT-V4500 only
STEP 2
Connecting a
Super Woofer (LBT-V4500
only)
Connect the Super Woofer to the SUPER
WOOFER R and L connectors with the blue
cord to + and the black cord to –.
blue
black
Connect this portion
STEP 3
Connecting the
Aerial
AM loop
aerial
(supplied)
FM wire aerial* (supplied)
*Note: Extend it horizontally
To set up the AM loop aerial
To improve the FM reception
Connect an outdoor FM aerial to the FM 75
Ω terminal, using a 75-ohm coaxial cable.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
75-ohm coaxial cable
(not supplied)
To improve the AM reception
After you connect the AM aerial, connect a
6- to 15- meter (20- to 50- feet) insulated
wire to the AM terminal. Connect the y
terminal to ground.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
A M
ground wire to a gas pipe.
F M 7
5
Insulated wire (not
supplied)
Ground wire
(not supplied)
continue to next page
Chapter 1: Setting Up
screw clamp
A M
F M 7
5
Ground wire
(not supplied)
EN
5
screw clamp
A M
F M 7
5