Help In Case Of Malfunctions; Storage; Safety Notes And Residual Risks - wissner-bosserhoff Carisma Manual De Instrucciones

18. HELP IN CASE OF MALFUNCTIONS

Malfunction
made correctly
not performed
The side rail cannot be
Castors do not brake or do
not roll

19. STORAGE

The following activities must be performed when storing the bed:
1. Remove mains plug.
2. Remove accessories such as lifting pole, serving tray, etc.
3. Cover nursing home bed so that damage or scratches to paint cannot occur.
4. Apply date of storage (for the purpose of maintenance intervals).
Caution! The same conditions apply for storage as for the working environment
(see Section Application Environment).

20. SAFETY NOTES AND RESIDUAL RISKS

1) These instructions for use must be read and observed before the nursing
home bed is used.
2) The details of the nameplate must be observed.
3) Because two power units independent of one another are used for the
height adjustment, it is important, depending on the adjustment cycle, to
move the patient surface at least once per day to the end position (highest –
lowest position). This causes potential height differences in the patient
surface to be equalled out.
4) The bed may not be operated if it displays malfunctions that could cause a
hazard to persons, employees or third parties.
Page 92
Possible Cause
supply
and temperature safeguard has
switched off
in castors over time
Remedy
Check moving parts and remove any foreign bodies
Contact our Customer Service and request spare
part
Connect plug to power supply
Wait for cooling down phase (at least 20 min.,
depending on overload). If the system still does not
function, contact our Customer Service
Check moving parts and remove any foreign bodies
Contact our Customer Service
Remove impurities
Contact our Customer Service