Sears Kenmore 85.12314 Manual De Instrucciones página 28

Bobbin winding (continued)
[] Push the bobbin to the right°
[] With free end of the thread held in your hand, depress the
foot control. Stop the machine when it has made a few turns,
and cut the thread close to the hole in the bobbin.
[] Depress the foot control again. When the bobbin is fully
wound, it stops automatically, Return the bobbin winder to its
original position by moving the spindle to the left and cut the
thread.
[] Push the handwheet to the left to engage crutch
*The machine does not function until the clutch is
engaged.
NOTE" Position of the bobbin winder stopper is adjustable for
the required amount of thread on bobbin (example 1/2
full or full etc.). Use a screwdriver and loosen the screw
one turn or less to adjust the position of the bobbin winder
stopper. Do not take out the screw all the way_
[][]
[]
[]
............. J
2O