Tabla de contenido
Publicidad
IMPORTANT
SAFETY INSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use
Read alt instructions before using this sewing machine1.
DANG ER
-
To reduce the risk of electric shock:
1. This sewing machine should never be left unattended when plugged in Always unplug this sewing machine from the
electric outlet immediately after using and before cleaning°
2. Always unplu_ before replacing a sewing machine bulbo Replace bulb with same type rated 15 Watts_
3.
Do not reach for a sewing machine that has fallen into water° Unplug immediately..
4_ Do not place or store this sewing machine where it can fail or be pulled into a tub or sink. Do not place or drop it into water
or other liquid.
WAR N !N G
-
To reduce the risk of burns, fire, electric shock, or injury to persons:
1_ De not allow this sewing machine to be used as a toy° Close attention is necessary when this sewing machine is used by
or near children..
2. Use this sewing machine only for its intended use as described in this owner's manual,.
Use only attachments recommended by the manufacturer as contained in this owner's manual.
3
Never operate this sewing machine ff it has a damaged cord or plug, ff it is not working properly, if it has been dropped
or damaged, or dropped into water..
Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment,
4. Never operate this sewing machine with any air opening blocked. Keep ventilation openings of this sewing machine and
foot controller free from accumulation of lint, dust and loose cloth.
5.
Never drop or insert any object into any opening.
6° Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered
8. To disconnect, turn all controls to the off (" 0")
position, then remove plug from outleL
9.. Do not unplug by pulling on cord° To unplug, grasp the plug, not the cord
10,.Keep fingers away from all moving parts. Special care is required around the sewing machine needle,
11, Always use the proper needle plate_ The wrong plate can cause the needle to break.
12, Do not use bent needles.
!3. Do net pull or push fabric while stitching. It may deflect the needle causing it to break.
14_Switch this sewing machine off (" 0")
when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin or changing the presser foot, and the like,
15_Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual..
SAVE THESE INSTRUCTIONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run
I
1
the machine without thread for a few minutes Wipe away any oil which may appear_
I
Publicidad
Tabla de contenido
