Configuration Previous To The Reproduction; Adjustments During The Reproduction - CESVA FP122 Manual Del Usuario

4.1.2 Configuration previous to the reproduction

To configure the FP122, follow the next stops:
3) Switch on the AP602 through the main switch [11]
4) Verify that the source to reproduce is set to INTERNAL
SOURCE key
5) Verify that the volume level is lower than -20 dB. If not, decrease it with the
key.
6) Press the PLAY key
and the selected noise will be reproduced in the BP012 loudspeaker. The
noise volume will be gradually increased during the first second till the
selected volume level will be reached.
NOTE:

To start the intermittent operation mode, hold the start key
seconds.

4.1.3 Adjustments during the reproduction

7) Adjust the volume with the keys:
8) During the reproduction, it is possible to change the type of noise (3.6)
through the key
9) To equalize the reproduced noise follow the next steps:
1. Press the key, till the indication
2. Then, with the
right part of the equalizer area, the central frequency of the selected third
octave band filter is shown.
3. Next, set the filter attenuation [-10 a 10 dB] with the
lower right part of the equalizer area, the attenuation of the selected third
octave band filter is detailed.
4. Repeat the process for the other filters that need adjustment.
5. If you want to deactivate the equalizer (bypass) press the
indication OFF
Chapter 4 Configuration and use of FP122
till the previous icon appears on the screen.
. The reproduction state indication will go from
and
.
keys select the filter you want to adjust. In the upper
appears on the screen.
. If not, press the
shows that the equalizer is active.
to
for 3
keys, in the
key, until the
51