Adjustments During The Reproduction; Configuration With External Signal Processing Equipment; Connecting Diagram With External Processing Equipment - CESVA FP122 Manual Del Usuario

4.2.3 Adjustments during the reproduction

See 4.1.3
NOTE:

The stop and start, equalizing and volume controls of the noise
reproduction concerns to the signal amplification stage. In this way, the
signal from the external generator can be controlled from the AP602
(remote control or AP602 software).

4.3 Configuration with external signal processing equipment

The AP602 allows you to insert external signal processing equipment between
the noise generator and the amplifier such as compressors, filters, etc.

4.3.1 Connecting diagram with external processing equipment

NOTE:

Always connect the equipment with the equipment turned off and consult
the chapter 8 about safety measures and advice.

Confirm that the external equipment does not amplify the signal.
1) Connect the AP602 and the BP012 with the Speakon-Speakon cable CN012.
In the AP602 you should connect the cable in the Speaker connector [24] and
in the BP012 side into the Speakon connector [2].
2) Connect the AP602 to the mains supply with the mains cable through the
mains connector [13].
3) Connect the line signal output GENERATOR OUTPUT of the AP602, XLR
connector [18], to the signal input of the external equipment.
4) Connect the signal output of the external equipment to the line signal input of
the AP602 SIGNAL INPUT, XLR connector [20].
5) Connect the external equipment to the mains.
6) Turn on the external equipment and the AP602.
54
Chapter 4 Configuration and use of FP122
1