Configuration Previous To The Reproduction With External Noise Generator - CESVA FP122 Manual Del Usuario

External noise generator
AP602
4.2.2 Configuration previous to the reproduction with external
noise generator
To configure the FP122, follow the next steps:
4) Switch on the AP602 with the main switch [11]
5) Verify that the source to reproduce is set to EXTERNAL
SOURCE key
6) Verify that the volume level is lower than -20 dB. If not, decrease it with the
key.
7) Press the PLAY key
and the selected noise will be reproduced in the BP012 loudspeaker. The
noise volume will be gradually increased during the first second till the
selected volume level will be reached.
NOTE:

To start the intermittent operation mode, hold the start key
seconds.
Chapter 4 Configuration and use of FP122
CN012
till the previous icon appears on the screen.
. The reproduction state indication will go from
BP012
TR012
. If not, press the
to
for 3
53