Displaying Audio Signal Information - Yamaha NP-S303 Manual De Instrucciones

MUTE MUTE DIMMER DIMMER
PRESET
PRESET
1 2 3
4 5 6
Preset
number
7 8 9
keys
10 MEMORY HOME HOME
MEMORY
REPEAT REPEAT SHUFFLE SHUFFLE NOW PLAYING NOW PLAYING
NET NET USB USB BLUETOOTH BLUETOOTH
Cursor keys
ENTER
ENTER
SETUP SETUP RETURN
RETURN
DISPLAY DISPLAY OPTION
OPTION
AMP AMP
INPUT INPUT VOLUME VOLUME
MUTE MUTE
40
En
Recalling a preset content
You can select an audio file from the registered preset numbers.
1
Press PRESET j / i or the preset number keys to
specify the preset number to select the content to
which you want to listen.
A few seconds after you select the preset number, playback
will start.
NOTE
• You can recall preset numbers 1 through 10 by using preset number keys.
• "No Presets" will appear if no items are registered.
• In the following cases, the selected preset item will not play.
– The connected USB storage device does not contain the registered audio
file.
– A PC that stores the registered item is turned off or is not connected to the
network.
– An Internet Radio station (that is registered as a preset) is temporarily off
air or out of service.
– The registered item (file) has been deleted or moved to another location.
• When you register a music file (stored on a USB storage device or a PC),
the unit memorizes the relative position of the music file in the folder.
Therefore, if you add or delete music files to or from the folder, the unit may
be unable to recall the preset music file correctly. In such cases, register the
item again.
• To cancel the recall operation, press RETURN.
• Even if the unit is in Standby mode, pressing a preset number key will turn
on the power to the unit and recall the corresponding preset content.

Displaying audio signal information

You can view information about the signal from the currently-
playing audio source.
1
Press OPTION.
2
Use the cursor keys (/) to select "Signal Info.",
and then press ENTER.
NOTE
• To return to the previous screen during menu operations, press
RETURN.
3
Use the cursor keys (/) to switch the display of
the audio signal information.
FORMAT Audio format
SAMPLING Number of samples per second
4
Press OPTION to complete the setting.