Connecting The Unit To The Network; Connecting To A Network By Using Musiccast Controller - Yamaha NP-S303 Manual De Instrucciones

5

Connecting the unit to the network

Select a connection method that is suitable for your environment.
This section describes how to use the MusicCast CONTROLLER app to connect the
unit to a wireless network.
If you want to connect the unit to a wireless network without using MusicCast
CONTROLLER, refer to page 23 for more information. To use MusicCast CONTROLLER
while the unit is connected to a network by cable, perform Steps 1 through 4 in the
section "Connecting to a network using MusicCast CONTROLLER".
The following functions are available only if you use the MusicCast CONTROLLER app.
• Playback music from music streaming services.
• Sending signals via Bluetooth (page 37)
NOTE
• If you want to play high-resolution audio sources via the network, a wired connection is
recommended for more stable playback (page 19).
• Your mobile device must already be connected to the wireless LAN router (access point).
• To manually connect the unit to a network wirelessly, have the SSID and security key for the
wireless router (access point) ready.

Connecting to a network by using MusicCast CONTROLLER

This section explains how to register the unit with MusicCast and set up the unit for the
network connection.
1
Install MusicCast CONTROLLER.
Download and install the MusicCast CONTROLLER app (free) to your mobile
device from the App Store or Google Play.
2
Start the MusicCast CONTROLLER app on your mobile device, and
then tap "Setup".
3
Follow the instructions on the display of the mobile device to operate
MusicCast CONTROLLER, and then press and hold down the
CONNECT on the front panel of the unit for 5 seconds.
"CONNECT" appears on the display and the WiFi indicator blinks.
USB
5V A
Wi-Fi indicator
SELECT
ENTER PUSH
SOURCE RETURN
Wi Fi
BLUETOOTH
CONNECT
CONNECT
21
En