Nuova Simonelli APPIA Instrucciones De Manejo página 41

7.6
PROGRAMMING OPE-
RATING PARAMETERS
CAUTION
The adjustments listed here below must
ONLY be performed by a Specialist
Technical Engineer
The page for setting operating parameters is
opened by pressing the
with the 2 espresso key
delivery is enabled:
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the
dose programming function.
3. Adjusting keypad brightness.
1. Enabling the pump during levelling.
Use the 1 espresso key
enabling during
if the key is lit, the pump is enabled
together with the level; if it is switched off, the
pump is not enabled with the level function
2. Enabling the software block to enter the
dose programming function.
Use the 1 long coffee key
software block to programme doses (key lit) or
to de-activate the block.
3. Adjusting keypad brightness.
The 2 long coffees key
flash, is used to choose the key brightness set-
ting from 5 pre-set levels.
key together
Use the key
while no
lowering it to minimum or returning it to maxi-
mum.
Press the continued key
programming function and return to the dose
programming function
to set pump
levelling:
to enable a
, which will
to change the level,
to exit the
37