Replacing The V-Belt; Cut-Off Machine Cart - Stihl TS 700 Manual De Instrucciones

English

Replacing the V-belt

4
2
6
1
5
6
6
The arrow on the tensioning nut (1)
N
must point to 0 – to this end, turn the
tensioning nut (1) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
Unscrew the nuts (2) from the studs
N
Remove the V-belt guard (3) and
N
remove the V-belt from the front
pulley
Remove the "support with guard".
N
Remove the hose (4) from the guide
N
of the starter cover (5)
Remove the screws (6) from the
N
starter cover
Remove the starter cover
N
Remove the defective V-belt from
N
the cast arm
48
8
3
Carefully fit a new poly V-belt (7) in
N
the cast arm and insert it in the front
poly V-belt pulley (8) on the engine
Fit the starter cover
N
Position the "support with guard"
N
against the cast arm
Fit the poly V-belt in the front poly V-
N
belt pulley (9)
Position belt guard
N
Align the studs in the support with
N
the nuts in the V-belt guard
Screw the nuts onto the studs – do
N
not tighten them yet
Place hose in the guide of the
N
starter cover
Continue as described in the chapter
"Tensioning the V-belt".

Cut-off Machine Cart

7
9
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
–
–
–
repair damaged roadways
apply roadway markings
cut expansion joints
TS 700, TS 800