AFG 3.1AT Manual Del Propietário página 10

5olAT ASSEMBLY STEP 1
I HARDWARE FOR STEP 1 : 1
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
8.2 mm
Qty: 6
Qty:SCREW(D)I 2 mm8 __ Qty:20SCREW(L)mm2
SCREWS (D)
SCREWS (L) _
MAIN FRAME BOOT _
MAIN FRAME
* This step is for 5.1AT models only. For 3.1AT models,
proceed to page 12.
B
C
Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
Open HARDWARE FOR STEP 1.
Place MAIN FRAME BOOTS over MAIN FRAME as
shown.
D Attach MAIN FRAME BOOTS to MAIN FRAME
using 8 SCREWS (D) from above and 2 SCREWS
(L) from the front.