Chapter 3. Quick Installation Guide; Tcp/Ip Configuration - Multilaser RE027 Manual Del Usuario

www.multilaser.com.br
Chapter 3. Quick Installation Guide
This chapter will show you how to configure the basic functions of your RE027 150Mbps Wireless N
Router using Quick Setup Wizard within minutes.
3.1 TCP/IP Configuration
The default IP address of the RE027 150Mbps Wireless N Router is 192.168.1.1. And the default Subnet
Mask is 255.255.255.0. These values can be changed as you desire. In this guide, we use all the default
values for description.
Connect the local PC to the LAN ports of the Router. And then you can configure the IP address for your
PC in the following two ways.
• Configure the IP address manually
1) Set up the TCP/IP Protocol for your PC. If you need instructions as to how to do this,
please refer to Appendix B: "Configuring the PC".
2) Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is any
number from 2 to 254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1 (The Router's
default IP address)
• Obtain an IP address automatically
1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC.
If you need instructions as to how to do this, please refer to Appendix B: "Configuring the PC".
2) Then the built-in DHCP server will assign IP address for the PC.
Now, you can run the Ping command in the command prompt to verify the network connection between
your PC and the Router. The following example is in Windows 2000 OS.
117