Multilaser RE027 Manual Del Usuario página 125

www.multilaser.com.br
- Region – Select your region from the pull-down list. This field specifies the region where the wireless
function of the Router can be used. It may be illegal to use the wireless function of the Router in a region
other than one of those specified in this field. If your country or region is not listed, please contact your
local government agency for assistance.
- Channel – This field determines which operating frequency will be used. The default channel is set to
Auto. so the AP will choose the best channel automatically. It is not necessary to change the wireless channel
unless you notice interference problems with another nearby access point.
- Mode – This field determines the wireless mode which the Router works on.
- Channel Width – Select any channel width from the pull-down list. The default setting is automatic,
which can adjust the channel width for your clients automatically.
- Max Tx Rate – You can limit the maximum transmission rate of the Router through this field.
- Disable Security – The wireless security function can be enabled or disabled. If disabled, the wireless
stations will be able to connect the Router without encryption. It is recommended strongly that you choose
one of following options to enable security.
- WPA-PSK/WPA2-PSK – Select WPA based on pre-shared passphrase.
- No Change – If you chose this option, wireless security configuration will not change!
These settings are only for basic wireless parameters. For advanced settings, please refer to Section 4.6:
"Wireless".
Figure 3-10. Click the Finish button to finish the Quick Setup.
Senha PSK – Você pode utilizar caracteres ASCII ou Hexadecimais.
•
For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z, the length should
be between 8 and 63 characters.
For Hexadecimal, the key can be made up of any numbers 0 to 9 and letters A to F, the length should
be between 8 and 64 characters.
Please also note the key is case sensitive, this means that upper and lower case keys will affect the
outcome. It would also be a good idea to write down the key and all related wireless security settings.
6. Click the Next button. You will then see the Finish page.
If you don't make any changes on the Wireless page, you will see the Finish page as shown in
123