•
Connect Automatically – The connection can be re-established automatically when it was down.
•
Time-based Connecting – The connection will only be established in the period from the start time to the end time (both
are in HH:MM format).
Note:
Only when you have configured the system time on "System Tools > Time" page, will the Time-based Connecting function can take effect.
•
Connect Manually – You can click the Connect/Disconnect button to connect/disconnect immediately. This mode
also supports the Max Idle Time function as Connect on Demand mode. The Internet connection can be disconnected
automatically after a specified inactivity period and re-established when you attempt to access the Internet again.
Click the Connect button to connect immediately. Click the Disconnect button to disconnect immediately.
Caution: Sometimes the connection cannot be terminated although you specify a time to Max Idle Time because some applications are
visiting the Internet continually in the background.
If you want to do some advanced configurations, please click the Advanced button, and the page shown in Figure 4 10 will then appear:
138
•
MTU Size – The default MTU size is "1480" bytes, which is usually fine. It is not recommended that you change the
Figure 4 10 PPPoE Advanced Settings
www.multilaser.com.br