Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Limited by local law regulations, version for North America does not have region selection option.
•
Channel - This field determines which operating frequency will be used. The default channel is set to Auto. so the AP will
choose the best channel automatically. It is not necessary to change the wireless channel unless you notice interference
problems with another nearby access point.
•
Mode - Select the desired mode. The default setting is 11bgn mixed.
11b only - Select if all of your wireless clients are 802.11b.
11g only - Select if all of your wireless clients are 802.11g.
11n only - Select only if all of your wireless clients are 802.11n.
11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.
11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
Select the desired wireless mode. When 802.11g mode is selected, only 802.11g wireless stations can connect to the Router.
146
When 802.11n mode is selected, only 802.11n wireless stations can connect to the AP. It is strongly recommended that you set
the Mode to 802.11b&g&n, and all of 802.11b, 802.11g, and 802.11n wireless stations can connect to the Router.
•
Channel width - Select the channel width from the pull-down list. The default setting is automatic, which can adjust the
channel width for your clients automatically.
Note:
If 11b only, 11g only, or 11bg mixed is selected in the Mode field, the Channel Width selecting field will turn grey and the value
will become 20M, which is unable to be changed.
•
Max Tx Rate – You can limit the maximum tx rate of the Router through this field.
•
Enable Wireless Router Radio – The wireless radio of this Router can be enabled or disabled to allow wireless stations access.
•
Enable SSID Broadcast – When wireless clients survey the local area for wireless networks to associate with, they will
detect the SSID broadcast by the Router. If you select the Enable SSID Broadcast checkbox, the Wireless Router will
broadcast its name (SSID) on the air.
•
WDS ativo – Check this box to enable WDS. With this function, the Router can bridge two or more Wlans. If this checkbox
is selected, you will have to set the following parameters as shown in Figure 4 17. Make sure the following settings are
correct
•
SSID(to be bridged) - The SSID of the AP your Router is going to connect to as a client. You can also use the search
Note Dialog
www.multilaser.com.br
Publicidad
Tabla de contenido
