Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
5-13/16"(148mm)
11/32" (9mm)
3 Holes
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40mm) plus the thickness of the work bench.
For example, use 2-9/16" (65mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
6mm Bolt
Holder
Adjust the holder
Move
until its bottom
surface contacts the
work bench surface.
Fig. 5
2. Install the side handle (Fig. 6)
Install the side handle that came enclosed with this unit.
Turntable
Fig. 6
3. Releasing the locking pin
Handle
Locking pin
10
11-21/32" (296mm)
Holder adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the holder until its bottom surface contacts the work bench surface.
After adjustment, fi rmly tighten the 6mm bolt.
Side handle
Tighten
When the power tool is prepared for shipping, its main parts are
secured by a locking pin.
Move the handle slightly so that the locking pin can be disengaged.
NOTE
Pull
Fig. 7
Base
Work Bench
Fig. 4
: Lowering the handle slightly will enable you to
disengage the locking pin more easily and safely.
The lock position of the locking pin is for carrying and
storage only.
5/16" (8mm) Bolt
5/16" (8mm) Nut
Publicidad
Tabla de contenido
