About Remaining Battery Indicator - Metabo HPT C 1810DFA Instrucciones De Seguridad Y Manual De Instrucciones

English
(6) Press in the spindle lock and tighten the bolt by
turning it to the left by standard accessorie's wrench
(5 mm Hex. bar wrench) as indicated in Fig. 36-b.
CAUTION
○ Confi rm that the spindle lock has returned to the
retract position after installing or removing the
saw blade.
○ Tighten the bolt so it does not come loose during
operation. Confi rm the bolt has been properly
tightened before the power tool is started.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting
procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the
safety cover.
Safeguard Function
Overburden Protection
Temperature Protection

ABOUT REMAINING BATTERY INDICATOR

1. About Remaining Battery Indicator on Tool Body
When the switch is ON, the remaining battery
indicator lamp lights and the battery remaining power
can be checked. (Fig. 3) The Table 6 shows the state
of remaining battery indicator lamp and the battery
remaining power.
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
28
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Table 6
Battery Remaining Power
The battery remaining power
is enough.
The battery remaining power
is a half.
The battery remaining power
is nearly empty.
Re-charge the battery
soonest possible.
CAUTION
Never attempt to install saw blades larger than
10 in. (255 mm) in diameter.
Always install saw blades that are 9-21/32"
(245 mm) to 10 in. (255 mm) in diameter.
LED LIGHT WARNING SIGNALS
This product features functions that are designed to
protect the tool itself as well as the battery. While the
switch is pulled, if any of the safeguard functions are
triggered during operation, the LED light will blink as
described in Table 5. When any of the safeguard functions
are triggered, immediately remove your fi nger from
the switch and follow the instructions described under
corrective action.
Table 5
Remove the cause of the overburdening.
Allow the tool and battery to thoroughly cool.
2. About Remaining Battery Indicator on Battery
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 37, Table 7)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Remaining battery
indicator lamp
Display panel
Corrective Action
Remaining battery
indicator switch
Fig. 37