Safety Notes - IMG STAGELINE CD-230USB Manual De Instrucciones

2 Safety Notes

The unit corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to
skilled personnel . Inexpert han-
dling may result in electric shock .
•
Caution! Never look into the CD mech-
anism when the CD tray (21) is open;
laser beams may be emitted causing eye
damage .
•
The unit is suitable for indoor use only . Pro-
tect it against dripping water, splash water
and high air humidity . The admissible ambi-
ent temperature range is 0 – 40 °C .
•
Do not place any vessel filled with liquid on
the unit, e . g . a drinking glass .
•
Immediately disconnect the mains plug
from the socket
1 . if the unit or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
unit was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the unit must be repaired by
skilled personnel .
•
Never pull the mains cable to disconnect
the mains plug from the socket; always
seize the plug .
•
No guarantee claims for the unit and no
liability for any resulting personal damage
or material damage will be accepted if the
unit is used for other purposes than orig-
inally intended, if it is not correctly con-
nected or operated, or if it is not repaired
in an expert way .
If the unit is to be put out of oper-
ation definitively, take it to a local
recycling plant for a disposal which
is not harmful to the environment .
3 Applications
The CD / MP3 player CD-230USB with two
replay units is especially designed for pro-
fessional DJ applications, offering special
features such as single title replay, various
replay effects, change of the replay speed to
up to ±16 % .
With this unit, audio CDs (including CD-Rs
and CD-RWs ) can be replayed . MP3 files can
1
be replayed from CDs, USB flash drives
SD / SDHC memory cards (32 GB max .) .
2
1 Depending on the type of CD, the CD burner and
the burning software used, problems may occur
when replaying CD-RWs .
4 Setting up /
Connecting the Unit
.
The control unit and the replay unit are de-
signed for installation into a rack for units
with a width of 482 mm (19"), but they can
also be used as tabletop units . The replay
unit must always be operated horizontally,
whereas the control unit can be installed
as desired, e . g . also inclined . For rack in-
stallation, 2 rack spaces each are required
for the control unit and the replay unit
(1 RS = 44 .45 mm) .
Prior to making or changing any connections,
switch off the CD-230USB and the units to
be connected!
1) Use the two connection cables provided to
connect the control unit to the replay unit:
Connect the jack CONNECT TO CONTROL
UNIT A (30) of replay unit A to the jack
CONNECT TO MAIN UNIT A of operating
unit A . Proceed in the same way to make
a connection between replay unit B and
operating unit B .
2) Connect each of the signal outputs LINE
OUT (28, 31) to a line level input of a mixer
or amplifier, for example (likely lettering:
Line, CD, Aux) .
3) Connect the mains jack (29) to a socket
(230 V/ 50 Hz) via the mains cable provided .
5 Operation
Switch on the unit with the POWER switch
(26) . During the reading process,
will appear on the display (7) . After that,
when a CD is inserted, the display will show
information about the CD; if no CD is in-
serted, will appear on the display .
NO DISC
1) To insert a CD, open the CD tray (21) with
the button (3 or 25) . Insert the CD with
the lettering facing upwards, and close the
CD tray with the button .
Note: The CD tray will be locked as long as a CD
is being replayed . If required, stop the replay with
the button (17) .
2) Additionally or as an alternative, insert a
USB flash drive 2
and / or
insert a memory card
SD / MMC (22) with the notched corner of
the card to the right and facing the unit .
To remove the card, push the card into the
slot until it disengages .
and 3) After switching on, the CD drives are
2
always selected . To select the USB flash
Due to the large number of storage device manu-
2
facturers and device drivers, it cannot be guaranteed
that all storage media are compatible with the
CD-230USB .
READING
into the USB port (23)
into the slot
2
drive or the memory card, press the button
CD / USB / SD (11) the appropriate number
of times . The LEDs (4) above the jog wheel
will indicate the replay medium selected .
Note: A different replay medium can only be
selected in the pause mode . If required, use the
button to set the player to pause .
4) All the other operating options are listed
in the tables on the following pages . After
operation, switch the CD/ MP3 player off
with the POWER switch .
6 Maintenance of the Unit
Protect the unit against dust, vibrations,
humidity and heat (admissible ambient tem-
perature: 0 – 40° C) . For cleaning only use a
dry, soft cloth; never use water or chemicals .
Note concerning sound interruptions and
reading errors
Cigarette smoke and dust will easily pene-
trate through all openings of the unit and will
also settle on the optics of the laser sampling
systems . If this deposit should cause reading
errors and sound interruptions, the unit must
be cleaned by skilled personnel . Please note
that there will be a charge on cleaning, even
during the warranty period!
7 Specifications
Frequency range: � � � � � � � 20 – 20 000 Hz
THD: � � � � � � � � � � � � � � � � < 0�1 %
Channel separation: � � � � > 80 dB
Dynamic range: � � � � � � � � > 90 dB
S / N ratio: � � � � � � � � � � � � > 80 dB
Output: � � � � � � � � � � � � � 2 V (line level),
RCA jacks
Anti-shock memory: � � � � for CDDA 10 sec�
for MP3 15 sec�
Power supply: � � � � � � � � � 230 V/ 50 Hz
Power consumption: � � � � 30 VA max�
Ambient temperature: � � � 0 – 40 °C
Dimensions (W × H × D)
Control unit: � � � � � � � � � 482 × 88 × 100 mm,
2 RS
Replay unit: � � � � � � � � � 482 × 88 × 270 mm,
2 RS
Weight: � � � � � � � � � � � � � � 5�9 kg
9