Warranty Term - TRAPP KM 300 Manual De Instrucciones

Metalúrgica Trapp Ltda.
Guarantees this product for one year,
warranty effected from date of purchase
stated on consumer invoice.
This product has full coverage against
manufacturing defects, defective parts,
and service cost. For servicing, customer
must take product to nearest authorized
TRAPP service dealer and present proof
of purchase
Warranty will be voided if product: is
damaged due to accident, was
improperly used, presents lack of
maintenance (not following instruction
stated on TRAPP Instruction Manual),
presents signs of violation, or has been
serviced by unauthorized dealer.
Warranty will also be voided if product
is exposed to humidity, bad weather,
corrosive sea air etc.
Warranty will not cover parts which
present natural wear.
Note:
All parts proven to be defective will
be replaced by manufacturer at no
cost. Under no circumstances will
machine/equipment be replaced
and/or exchanged.
Consumer is responsible for handling &
shipping product to the nearest TRAPP
authorized service dealer.
This warranty is limited and is
non-transferable, only valid upon
presentation of purchase invoice.
36

Warranty Term

This product is subject to modifications
in design and technical specifications
without prior notice from manufacturer.
Motor warranty covers the following
manufacturing defects:
Spiral short circuit, short circuit between
phases, rotor failure, and assembly error.
The following is not covered by the
warranty:
Failures caused by: inappropriate use
such as overload, lack of power, voltage
different from specified, capacitors, roller
bearings, broken shaft, broken or dented
housing or denting caused by careless
handling, shipping, or storage, motor
coupling or energization.
Note:
Always use original parts and
look for a TRAPP Authorized
Service Shop.
The use of non-original parts
is considered breach of
warranty.