Accessories; Troubleshooting - Ryobi RTS10NS Manual Del Operador

 Protect the blade by cleaning out sawdust from
underneath the table and in the blade teeth. Use a resin
solvent on the blade teeth.
 Clean plastic parts only with a soft damp cloth. DO
NOT use any aerosol or petroleum solvents.
Look for these accessories where you purchased this product or call 1-800-525-2579:
 Stand Assembly .........................................................................................................................................089037007708
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.
Problem
Excess vibration.
Rip fence does not move smoothly.
Rip fence does not lock at rear.
Cutting binds or burns work.
Wood edges away from rip fence when
ripping.
MAINTENANCE
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.

ACCESSORIES

TROUBLESHOOTING

Possible Cause
Blade is out of balance.
Blade is damaged.
Saw is not mounted securely.
Work surface is uneven.
Blade is warped.
Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp nut is out of adjustment.
Clamp nut is out of adjustment.
Blade is dull.
Blade is heeling.
Work is fed too fast.
Rip fence is misaligned.
Wood is warped.
Riving knife is out of alignment.
Blade not properly sharpened or set.
37 - English
Solution
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface.
Check saw blade installation. Replace
blade if necessary.
Remount the rip fence.
Clean and wax rails.
Adjust clamp nut counterclockwise.
Adjust clamp nut clockwise.
Replace or sharpen blade.
See Adjusting the Blade Parallel to
the Miter Gauge Groove (Removing
Heel) in the Operation section.
Slow the feed rate.
Align the rip fence.
Replace the wood. Always cut with
convex side to table surface.
See To Check and Align the Riving
Knife and Saw Blade in the Assembly
section.
Resharpen or set blade.