Troubleshooting Guide - DeWalt DWS780 Manual De Instrucciones

TROUBLE! WHAT'S WRONG?
Saw will not start Saw not plugged in
Fuse blown or circuit breaker tripped
Cord damaged
Brushes worn out
Saw makes unsatisfactory cuts Dull blade
Blade mounted backwards
Gum or pitch on blade
Incorrect blade for work being done
Blade does not come up to speed Extension cord too light or too long
Low house current
Machine vibrates excessively Saw not mounted securely to stand or work bench
Stand or bench on uneven floor
Damaged saw blade
Does not make accurate miter cuts Miter scale not adjusted correctly
Blade is not square to fence
Blade is not perpendicular to table
Workpiece moving
Material pinches blade Cutting bowed material

Troubleshooting Guide

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT TO DO
Plug in saw.
Replace fuse or reset circuit breaker.
Have cord replaced by authorized service center.
Have brushes replaced by authorized service center.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Turn blade around. Refer to Changing or Installing a New Saw Blade.
Remove blade and clean with turpentine and coarse steel wool or household oven cleaner.
Change the blade type. Refer to Saw Blades under Accessories.
Replace with adequate size cord. Refer to Additional Saftey Rules for Miter Saws.
Contact your electric company.
Tighten all mounting hardware. Refer to Bench Mounting.
Reposition on flat level surface. Refer to Familiarization.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Check and adjust. Refer to Miter Scale Adjustment under Assembly and Adjustments.
Check and adjust. Refer to Miter Scale Adjustment under Assembly and Adjustments.
Check and adjust fence. Refer to Bevel Square to Table under Assembly and Adjustments.
Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
Refer to Bowed Material under Special Cuts.
English
13