On/Off Switch; Overload Protection - IKRA EGN 2500 Manual De Instrucciones

6. Operating Instructions
WARNING: You may need help unpacking and
assembling the machine.
After unpacking and inspecting the shredder for damage,
proceed with the following steps:
6.1 Assembling the Garden Shredder
• Turn the shredder over.
• Fold both legs up and insert the supplied axle through
the openings.
• Place both washers on the left and ride side of the
axle.
• Place the supplied threaded spacer on the axle. Then
attach the wheels and finally the safety nuts with the
wheel covers.
WARNING: Be careful when leaning the device
on the wheels, since the weight is unbalanced
when titled and moved.
6.2 Collecting Container
• Pull up the safety grip and slide the collecting contain-
er into the under frame.
GB | Operating Instructions
7. Operation

7.1 On/off switch

Press the on/off switch to switch on or off the shredder.

7.2 Overload protection

Overload (e.g. blocking up of the chopping knife) will lead
to a standstill of the machine after a few seconds. To pro-
tect the motor from getting damaged, the overload switch
will automatically cut off the mains supply.
• Wait at least 1 minute before restarting by first press-
• Remove the plug from the outlet.
• Loosen the hand screws and open up the upper part.
• Carefully clean the cutting and ejection elements. Re-
• Put the upper part back in place and attach the hand
GB-6
Note: This machine is equipped with an elec-
tromagnetic switch to prevent it from being
unexpectedly switched on when power source
recovered.
ing the reset button and then the on/off switch. If the
motor does not start, proceed as follows:
move any objects that could prevent cutting.
screws securely.
on/off
switch
Reset
button