Setting Warm Zone Control - Sears Kenmore 790.79992 Manual Del Usuario

Estufa a gas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting Warm Zone
Controls (if
equipped)
Use the warm zone to keep cooked
foods hot such as: vegetables, gravies,
casseroles, soups, stews, breads,
)astries and oven-safe dinner plates.
@
LO
OFF
HI
MED
Warmer Zone Control
Warm Zone Recommended Food
Settings Chart
Food Item
Heating
Level
Breads/Pastries
LO
Casseroles
LO
Dinner Plates with Food
LO
Eggs
LO
Gravies
LO
Meats
MED
Sauces
MED
Soups (cream)
MED
Stews
MED
Vegetables
MED
Fried Foods
HI
Hot Beverages
HI
Soups (liquid)
HI
The purpose of the warm zone is to keep hot cooked foods at serving
temperature, Always start with hot food, It is not recommended to heat cold
food on the warm zone,
All food placed on the warm zone should be covered with a lid or aluminum foil
to maintain quality
For best results, when warming pastries or breads, the
cover should have an opening to allow moisture to escape Do not use plastic
wrap to cover food. Plastic may melt onto the surface and be very difficult
to clean.
Use only dishware, utensils and cookware recommended for oven and cooktop
use on the warm zone,
Unlike the surface elements, the warm zone will not glow red
when it is hoL
Always use potholders or oven mitts when removing food from
the warm zone as cookware and p_ates will be hot,
To Set the Warm Zone Control
1
To set the control, push in and turn the knob, The temperatures are
approximate, and are designated by HI, MED and LO, However, the control
can be set at any position between HI and LO for different levels of
heating.
2,
When done, turn the control to OFF The warm zone will remain warm until
the hot surface indicator light goes off,
Temperature Selection
Refer to the chart in the side column for recommended heating levels, If a
particular food is not listed, start with the medium level, and adjust as needed
Most foods can be kept at serving temperatures by using the medium level,
The hot surface indicator light, located on the control panel, will come on
when the control is set and will continue to glow until the glass cooktop has
cooled down to a moderate level,
Hot Surface Indicator
Warm Zone Control
Warm Zone surface area
/
......
i!....

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido