Operation - Husqvarna 525DEPS Manual Del Usuario

4. Pull the shaft straight out of the coupling.
To assemble the impact guard
1. Assemble the guard with 3 screws.
2. Tighten the screws to 30 ft/lbs (4 Nm).
3. Tighten the screws again when the product has been
in use for about 20 hours.
To attach the harness support hook
• Attach the harness support hook on the product with
the spacer, the bolt, the nut and the knob.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
12
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is roughly level with your right hip.

Operation

To check before starting
1. Inspect the working area. Remove any objects that
could be thrown out.
2. Check the saw chain. Never use blunt, cracked or
damaged equipment.
1480 - 003 - 05.08.2020