To Adjust The Idle Speed; To Do Maintenance On The Muffler; Cooling System - Husqvarna 525DEPS Manual Del Usuario

Maintenance
Do an inspection of the dielectric shaft for worn and damaged areas. Do not use
the product if the dielectric shaft has worn or damaged areas. Refer to OSHA
1910.269 for more information.

To adjust the idle speed

1. Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
2. Start the product. Refer to
page 14
3. Adjust the idle speed with the idle adjustment screw
T which is identified with "T" mark. Turn the idle
adjustment screw clockwise until the saw chain
starts to turn.
4. Turn the idle adjustment screw counterclockwise
until the saw chain stops.
The idle speed is correct when the engine operates
smoothly in all positions. The idle speed must be below
the speed when the saw chain starts to turn.
WARNING: If the saw chain does not stop
when you adjust the idle speed, turn to your
nearest servicing dealer. Do not use the
product until it is correctly adjusted or
repaired.
Technical data on page 26 for the
Note: Refer to
recommended idle speed.

To do maintenance on the muffler

The muffler decreases the noise level and directs the
exhaust gases away from the operator.
WARNING: Mufflers that have catalytic
converters get very hot during operation and
will stay hot for some time after you stop the
product. This also applies at idle speed. If
you touch the product it can result in burns
to the skin. Think about of the risk of fire.
1. Stop the product and let it cool down.
18
To start the product on
2. Remove the cover to the muffler.
3. Remove the screw holding the spark arrestor mesh.
4. Clean the spark arrestor mesh if it is blocked or
replace it if it is damaged.
CAUTION: The spark arrestor mesh must be
replaced if it is damaged. Do not use a
product if the spark arrestor mesh on the
muffler is missing or defective.
CAUTION: If the spark arrestor mesh is
frequently blocked it can be a sign that
performance of the catalytic converter is
decreased. Turn to your servicing dealer to
examine the muffler. A blocked spark
arrestor mesh will cause overheating and
result in damage to the cylinder and piston.

Cooling system

The product has a cooling system to keep the operation
temperature as low as possible.
Clean the components of the cooling system with a
brush weekly or more frequently in rougher conditions. A
dirty or blocked cooling system makes the product too
hot which causes damage to the piston and cylinder.
The cooling system has the following components:
1. Air intake on the starter.
2. Fins on the flywheel.
Daily Weekly Monthly
X
1480 - 003 - 05.08.2020