Operating Elements And Connections; General Safety Notes - IMG STAGELINE LSE-150RG Manual De Instrucciones

All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 Setscrew (2 ×) for the mounting bracket
2 Outlet area of the laser beams
3 Mounting bracket
4 POWER LED
5 LED MUSIC: shortly shows blue when a sound
of sufficient volume has been picked up by the
microphone (7) to control the laser beams
6 Key switch LOCK to switch on the laser beams
The key is used by the laser protection adviser
to secure the unit against unauthorized opera-
tion.
7 Microphone for music control
8 Safety lug to fix a safety rope
9 Display
10 On / off switch
11 Support for the mains fuse
Only replace a blown fuse by one of the same
type
12 Mains jack for connection to a socket (230 V~ /
50 Hz) via the supplied mains cable
13 Connection for a remote control
14 Control for the sensitivity of response in case of
music control via the microphone (7)
15 Operating buttons
Button FUNC to select a function
Buttons DOWN and UP to adjust the DMX start
address or to select a show programme
Button ENTER to memorize a function
16 DMX signal output (3-pole XLR) for connection
to the DMX input of another DMX light effect
unit;
pin 1 = ground, pin 2 = DMX-, pin 3 = DMX+
17 DMX signal input (3-pole XLR) for connection of
a light controller;
pin 1 = ground, pin 2 = DMX-, pin 3 = DMX+
8
2 Safety Notes
The unit corresponds to all required directives of
the EU and is therefore marked with
2.1 Notes especially for laser units
This laser corresponds to the class 3b. The lasers
have the following power and wavelengths:
green laser
red laser
WARNING 1.The unit must be installed so that
nobody will be able to look directly
into the laser beam. Already a short
radiation on the retina may cause
permanent damage. Unintentional
reflections must be prevented.
2. The laser area must be limited and marked dur-
ing operation.
3. A laser protection adviser must be appointed in
writing and be present during operation (regu-
lation BGV B2 of the German employerʼs liabil-
ity insurance).
4. The operation of the laser must be notified at
the employerʼs liability insurance association
and the trade board.

2.2 General safety notes

WARNING The unit is supplied with hazardous
mains voltage. Never make any
modification on the unit and do not
insert anything through the air vents!
This may cause an electric shock
hazard.
It is essential to observe the following items:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient tempera-
ture range 10 – 40 °C).
G
Do not place any vessels filled with liquid, e. g. a
drinking glass, on the unit.
G
Do not set the unit into operation, and immedi-
ately disconnect the mains plug from the mains
socket if
1. there is visible damage to the unit or to the
mains cable,
2. a defect might have occurred after a drop or
similar accident,
3. malfunctions occur.
The unit must in any case be repaired by skilled
personnel.
.
Power Wavelength
40 mW 532 nm
100 mW 650 nm