The Evenfeed Foot Optional Accessory - Singer 3116 Manual De Instrucciones

3
e
a
2
C
d
a
80
The evenfeed foot optional accessory
* The evenfeed foot accessory is optional. It is not included with this
machine.
Always try to sew first without the evenfeed foot accessory which
should be used only when necessary.
It is easier to guide the fabric and you have a better view of the seam
when using the standard, regular foot on your machine. Your sewing
machine offers excellent stitch quality on a wide range of fabrics from
delicate chiffons to multiple layers of denim.
The evenfeed Foot accessory equalizes the feeding of the upper and
lower layers of fabric and improves the matching of plaids, stripes and
patterns. It also helps to prevent uneven feeding of very difficult
fabrics.
1. Lift the presser foot lifter to raise the presser foot bar (1).
2. Remove the presser foot holder by unscrewing (counterclockwise)
the presser bar attaching screw (2).
3. Attach the evenfeed foot to the machine as follows:
i) The arm (3) should fit into above the needle screw and clamp (4).
ii) Slide the plastic attaching head (5) from your left to right so that
it is fitted into the presser foot bar.
iii) Lower the presser foot bar (1).
iv) Replace and tighten (clockwise) the presser bar attaching screw
(2).
4. Make sure both the needle screw (4) and the presser bar attaching
screw (2) are tightly secured.
5. Draw the bobbin thread up and place both the bobbin thread and
the needle thread behind the walking foot attachment.
a.Arm
b.Attaching head
c. Needle bar
d. Needle screw & clamp
e. Presser foot bar
f. Presser bar attaching screw