BMF 203K-H- _ _ -C-A _ -... / BMF 235K-H- _ _ -C-A _ -...
Magnetic Field Sensors
6
Startup
6.1
Starting up the system
Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This could
result in personal injury and equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Turn on the system.
3. Check measured values and adjustable parameters
and readjust the BMF if necessary.
Check for the correct values, especially after
replacing the BMF or after repair by the
manufacturer.
6.2
Operating notes
–
Regularly check function of the BMF and all associated
components.
–
Take the BMF out of service whenever there is a
malfunction.
–
Secure the system against unauthorized use.
–
Check fasteners and re-tighten if needed.
14
english
DANGER