Manually Teaching Switchpoints; Teaching In Switchpoint S1 - Balluff BMF 203K-H- C-A-PU Serie Manual De Instrucciones

BMF 203K-H- _ _ -C-A _ -... / BMF 235K-H- _ _ -C-A _ -...
Magnetic Field Sensors
5

Manually teaching switchpoints

NOTICE
Damage from pointed objects.
Operating the button with pointed objects may result in
damage.
► Do not press the button with a pointed object.
– Only teach in switchpoints when installed.
– Ferromagnetic material in the direct vicinity of
the sensor can change the sensor's behavior.
– To teach in the switchpoints, remove the Allen
wrench from the screw head.
12 english
5.1

Teaching in switchpoint S1

1. Pull out the piston rod up to the first desired position.
Fig. 5-1: Extend the piston rod
2. Press and hold the button.
⇒ The green LED begins to flash, indicating that
teach-in mode is active.
Fig. 5-2: Green LED flashes
⇒ After 3 seconds, the yellow LED (switchpoint S1)
will also begin to flash.
Fig. 5-3: Green and yellow LEDs flash
3. Release the button.
⇒ The sensor is now ready for teaching in the first
switchpoint.
4. Press the button once more briefly.
⇒ Switchpoint S1 is saved and the green LED is lit
constantly.
⇒ If the piston remains unchanged in position 1, the
yellow LED also lights up now. This means output
S1 is switched on.
Fig. 5-4: Green and yellow LEDs on