Removing The Shelf Supports - Brandt BXP-6577 Manual De Instrucciones

ENGLISH
OPERATING THE AUTO FUNCTION:
This cooking mode takes place in two phases:
- 1) A data search phase during which the oven
begins heating and determines the ideal cooking
time. This phase lasts between 5 and 40 minutes
depending on the dish.
The oven offers a choice of 9 dishes:
P01: Pizza
P02: Rost beef rare
P03: Rost beef medium
P04: Rost beef welldone
P05: Roast pork
P06: Chicken
P07: Fish
P08: Savoury tart
P09: Cakes
Select the function AUTO with
pressingChoose your programme with
then confirm by pressing OK.
You can change the cooking finish time before
putting your dish
recommended shelf level.
- Confirm by pressing the OK button to start
cooking.
An animation - - is displayed alternating with the
cooking time symbol throughout this calculation
phase.
- 2) A second cooking phase: the oven has
calculated the necessary time, the animation
disappears. The remaining cooking time indicated
takes into account the cooking time from the first
phase. You can now open the door (e.g. to baste a
roast).
- The oven beeps and turns off when the cooking
time is over and your screen then indicates that the
dish is ready.
DELAYED START FUNCTION
To program a delayed start:
- Select the cooking end function and change the
cooking end time.
PLEASE NOTE: If you want to program a subsequent
AUTO cooking cycle, wait until the oven has cooled
completely. However, you can use the "Expert"
function even if the oven is hot.
. Confirm by
into the oven at
7
CLEANING THE OUTER SURFACES
Use a window washing product applied to a soft
cloth. Do not use abrasive creams or scouring
sponges.
PYROLYSIS CLEANING
Before starting pyrolysis cleaning, remove any
large overspills, if any. Remove the excess
grease on the door using a damp sponge.
As a safety measure, cleaning only occurs
after the door locks automatically; it is
impossible to unlock the door.
Remove the accessories and supports
from the oven before beginning pyrolysis
cleaning.
and
7.1

REMOVING THE SHELF SUPPORTS

the
Lift the front part of the wire shelf support upwards.
Press the entire shelf support and release the front
hook from its housing. Then gently pull the whole
of the support towards you to release the rear
hooks from their housing. Pull out the two shelf
supports.
7.2
IMMEDIATE PYROLYSIS
Depending on the model, two cleaning cycles are
available:
> Pyro 2h00,non modifiable (oven cooling time
30 additional minutes).
> PyroExpress in 59 minutes.
The PyroExpress function benefits from the heat
accumulated during the previous cooking session to
rapidly clean a slightly soiled oven using the
principles of pyrolysis, in under one hour, depending
on certain conditions.
PyroExpress is only possible if your oven is
still sufficiently hot, just after cooking. If this
is not the case, a 90-minute classic pyrolysis
cycle will automatically begin.
To activate pyrolysis, select the pyrolysis function of
your choice. Confirm by pressing OK.
The symbol
time for which the oven will be unavailable. The door
is locked during pyrolysis; the symbol
appear on the display. At the end of the cleaning
cycle, 0:00 will appear on the display and the door
will be unlocked.
Cleaning
displays as well as the length of
will