Notes To The User; Symbols And Conventions; Scope Of Delivery; Approvals And Markings - Balluff BTL7-A -M -A-S32 Serie Manual De Instrucciones

BTL7-A/C/E/G_ _ _-M_ _ _ _-A/B/Y/Z(8)-S32/S115/S135/S140/KA_ _/FA_ _
Magnetostrictive Linear Position Sensor – Rod Style
1

Notes to the user

1.1 Validity
This guide describes the construction, function and setup
options for the magnetostrictive linear position sensor with
analog interface. It applies to types
BTL7-A/C/E/G_ _ _-M_ _ _ _-A/B/Y/Z(8)-S32/S115/S135/
S140/KA_ _/FA_ _(see Type code on page 29).
The guide is intended for qualified technical personnel.
Read this guide before installing and operating the BTL.
1.2

Symbols and conventions

Individual handling instructions are indicated by a
preceding triangle.
► Handling instruction 1
Handling sequences are numbered consecutively:
1. Handling instruction 1
2. Handling instruction 2
Note, tip
This symbol indicates general notes.
These symbols indicate the buttons on the
1 2
calibration device.
Symbols of this type indicate the LED displays.
1.3

Scope of delivery

– BTL
– Calibration device (not for BTL7-...-S140)
– Condensed guide
The magnets are available in various models
and must be ordered separately.
1.4

Approvals and markings

Not for BTL7-...-FA_ _
US Patent 5 923 164
The US patent was awarded in connection with this
product.
www.balluff.com
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
The BTL meets the requirements of the following product
standard:
– EN 61326-2-3 (noise immunity and emission)
Emission tests:
– RF emission
EN 55011
Noise immunity tests:
– Static electricity (ESD)
EN 61000-4-2
– Electromagnetic fields (RFI)
EN 61000-4-3
– Electrical fast transients (burst)
EN 61000-4-4
– Surge
EN 61000-4-5
– Conducted interference induced by
high-frequency fields
EN 61000-4-6
– Magnetic fields
EN 61000-4-8
More detailed information on the guidelines,
approvals, and standards is included in the
declaration of conformity.
By using the DNV GL symbol
the marked products were type tested according
to the guidelines of DNV GL.
The type approval is authenticated with a
certificate (www.balluff.com).
Therefore, the marked products can be used
according to the specifications of the certificate
on ocean-going and inland vessels and on
offshore operations in systems subject to
mandatory type-testing.
Maximum length:
– BTL7-...-A/B/Y/Z-...: 300 mm (500 mm
when supported at the end of the rod using
slide bush BAM PC-TL-001-D10,4-4 in bore
with a diameter of max. 13 mm)
1)
Not for BTL7-...-S140
Severity level 3
Severity level 3
Severity level 3
Severity level 2
Severity level 3
Severity level 4
, we confirm that
1)
english 5