Basic Functions - PIAGGIO 1D001230 Instrucciones De Uso

ENABLING:
By pressing key A of the remote control or inputting the ELECTRONIC key in its housing, the system is
engaged, notifying the event by flashing the turn signals, issuing a sound and turning on with fixed light, the
led installed on-board the vehicle. From this moment, the vehicle can no longer be started if the engine box
is connected.
NOTES:
If the anti-theft function is not programmed, it is not possible to activate the system with the vehicle's
•
panel on.
Should the system's perimetric input detect an anomaly during the activation phase (E.g. open seat
•
or lifted stand), this will notify it by issuing a sound, after four seconds from activation and in addition
to the usual signals, that will persist as long as the flashing time of turn signals.
NEUTRAL TIME:
Once the activation signals have stopped, the system goes in "neutral time" status, a condition notified by the
activation of the led with fixed light. In this status, the alarm does not notify any vehicle's thefts. The neutral
time lasts 30 seconds.
During the neutral time, it is possible to perform the operating test of sensors, by tilting the vehicle,
connecting an instantaneous input to a positive charge (if configured as perimetric input) or by enabling the
activation panel; the alarm will confirm the sensor's operation by issuing a sound signal.
EXCLUSION OF THE TILTING SENSOR AND SIREN:
During the neutral time, it is possible to exclude the siren by pressing key B. The siren's exclusion will be
confirmed by the issuing of a sound signal and flashing of the turn signals. In this status, in case of alarm,
the device will only activate the turn signals. Once the alarm is engaged, the regular operation of the device
will be restored.
If the tilting sensor must be excluded instead, this can be done by simply pressing key C of the remote
control during the neutral time. The sensor's exclusion will be confirmed with the issuing of two sound signals
and two flashing of the turn signals. The system thus configured will notify any vehicle's theft attempts only in
case of non-authorised activation of the panel or in case of activation of the instantaneous input. Also in this
case, once the alarm is engaged, the regular operation of the device will be restored.
ALERT:
Once the neutral time has elapsed, the system goes in alert status, signalled with the activation of the leds
with flashing light. In this condition, the system is ready to signal any theft attempt towards the vehicle. The
led will flash as described below:
Within the first 30 sec after the elapsing of the neutral time: one flashing approx. every 2 sec.
•
ALARM:
Should a theft attempt occur during the alert period (non-authorised activation of the vehicle's panel, tilting or
movement of the vehicle, activation of an instantaneous input if configured as perimetric input) the alarm will
immediately notify it by activating the high-volume siren and flashing the turning signals repeatedly for
approx. 30 sec. In case the cause that triggered the alarm persists, the system will repeat a new alarm cycle,
with the limitations indicated below.
CAUSE OF ALARM
Panel activation
Tilting sensor
Instantaneous input
Self-powering

BASIC FUNCTIONS

ALARM DURATION
30 sec.
30 sec.
30 sec.
30 sec.
MAXIMUM NUMBER OF
CYCLES
Unlimited
5 cycles
5 cycles
Unlimited