PIAGGIO 1D001230 Instrucciones De Uso página 20

ADJUSTING OF OPERATING PARAMETERS
The alarm system has implemented a digital tilting sensor. It protects the vehicle against potential thefts, by
constantly monitoring its inclination.
After installing the alarm, adjust the system's sensitivity according to the type of vehicle on which the alarm is
installed.
The parameters can be adjusted with the remote control, following the procedure below.
ATTENTION:
The tilting sensor must be carefully adjusted, always trying to reach a good compromise between maximum
sensitivity without incurring in the risk of false or useless alarms.
ADJUSTMENT OF THE SENSITIVITY OF THE TILTING SENSOR:
To adjust the sensitivity of the tilting sensor, proceed as follows:
1. Enable and disable the activation panel three times, at the third activation, leave it on.
2. Wait approx. 0.5 sec. between turning on and off the panel.
3. Upon the third activation (leaving the panel enabled), the LED will emit a series of flashing to notify
the input in programming mode.
4. Within 5 sec., press key "A" and B" of the remote control; the alarm will notify the beginning of the
adjustment procedure by emitting a sound signal in acute mote and a series of five sequential
flashing of the led. Each flashing of the led corresponds to a sensitivity threshold of the sensor as
described below:
1 flashing of the led:
2 flashing of the led:
3 flashing of the led:
4 flashing of the led:
5 flashing of the led:
Carefully count the flashing emitted by the led; once the required triggering threshold is reached, turn off the
activation panel. The alarm will confirm the acquisition of the sensor's triggering threshold by emitting a long
sound signal in acute tone.
MANAGEMENT OF ELECTRIC CONNECTIONS IN THE MAIN CONNECTOR
Triggering threshold equal to 2
Triggering threshold equal to 4
Triggering threshold equal to 5°
Triggering threshold equal to 7°
Triggering threshold equal to 9°
1 Positive + 12 Vdc
2 Positive under key (+15)
3 Electronic key input
4 LED positive output
5 Turn signal output
6 Turn signal output
7 Power supply
8 (positive) perimetric input Boot/ Seat
Input for the manual acknowledgement of the "air bag reminder"
with system disabled (programmable selection,
9 NC engine block
10 (COM) engine block
11 (NA) engine block
12 Positive output, activation of auxiliary/ control modules of the seat's
actuator