PIAGGIO 1D001230 Instrucciones De Uso página 16

For further information, see the table below:
Beginning of programming procedure:
Enable the vehicle's activation panel three times.
At the third activation, leave the panel on.
Wait approx. 0.5 sec. between one activation and the
other of the panel.
Press key "C" of the remote control (within 5 sec.)
The alarm emits three sound signals combined to three
flashing of the led, then it emits a flashing of the turn
signals, a grave sound signal and turns off the led, thus
reaching the status for programing the first function.
1 AIR BAG reminder function
2 PIN 8 configuration
3 ON/OFF sound signals
4 Passive
5 Accidental anti-disengaging
6 Pre-alarm
7 Anti-theft
8 Modules output management
9 Enabling of TILTING sensor
NOTES:
Should the anti-theft function be used, in order not to incur in potential problems caused by the accidental enabling of the function when the vehicle is
•
running, the engine's electric block must be foreseen during system installation, which interrupts the engine's start-up circuit.
To complete the system's programming, simply turn off the activation panel at any time and any point of the programming phase; all parameters set in
•
this set will remain stored. To change a function, wait at least 5 sec. from a programming phase and the other.
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off, emission of a sound signal in grave tone).
Press key "C" to go to the following function
The alarm emits two sound signals and two flashing of the turn signals
Press key "B" to configure PIN 8 as perimetric input (Led on, emission of a sound signal in acute tone).
Press key "B" to configure PIN 8 as acknowledgement of the air bag reminder (led off, emission of a sound signal in
grave tone).
Press key "C" to go to the following function
The alarm emits three sound signals and three flashing of the turn signals
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off)
Press key "C" to go to the following function
The alarm emits four sound signals and four flashing of the turn signals
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off)
Press key "C" to go to the following function
The alarm emits five sound signals and five flashing of the turn signals
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off)
Press key "C" to go to the following function
The alarm emits six sound signals and six flashing of the turn signals
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off)
Press key "C" to go to the following function
The alarm emits seven sound signals and seven flashing of the turn signals
Press key "B" to enable (Led on, emission of a sound signal in acute tone).
Press key "B" to disable (Led off)
Press key "C" to go to the following function
The alarm emits eight sound signals and eight flashing of the turn signals
Press key "B" for ON modules output after 5 sec. from activating the system (Led on, emission of a sound signal in
acute tone).
Press key "B" to switch the output from modules control to seat-release actuator control. (Led off, emission of a
sound signal in grave tone).
Press key "C" to go to the following function
The alarm emits nine sound signals and nine flashing of the turn signals
Press key "B" to enable the ANTI-LIFTING sensor (Led on, emission of a sound signal in acute tone).
Press key "B" to deactivate the ANTI-LIFTING sensor (Led off)
Function enabling/ disabling mode