Install Rs485 For Jandy Automation - Zodiac Jandy Pro TruClear Manual De Instalación Y Funcionamiento

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Page 14

ENGLISH

Wires must

Violet

be connected

together when

White

wiring for

240VAC

Red

Figure 4.

Wiring with a 240 VAC Filter Pump

Wire power pack to pool pump power source

using 3.3 mm

(12 AWG) insulated wire and

conduit. Wire the power pack to the LOAD side

of the fi lter pump or the LOAD side of the pool

pump timer relay so that the chlorinator can

only come on when the pool pump comes on

(see Figure 4 for 240 VAC and Figure 5 for 120 VAC).

Remove the electrical mounting plate that feeds the

power cable to the power pack.

Feed the power cable through the mounting plate.

Connect the conduit to the mounting plate.

Make the wire connections. Note: The green

wire should be connected to the ground point.

(see Figure 4 for 240 VAC and Figure 5 for 120 VAC).

Place all of the wire connections and cables inside

the power pack and secure the electrical mounting

plate tightly.

WARNING

Select field conductor size appropriately, taking into

consideration length of circuit and in accordance with

applicable installation codes. The ground conductor

must be minimum 12 AWG.

Plug the cell into the Power Pack.

Jandy

Pro Series TruClear

Chlorine Generating System

™

Black

Green

Black

Ground

Figure 5.

3.6

The power pack comes equipped with a slide out RS485

connector. The RS485 connector is used to connect the

Jandy TruClear chlorination system to a new or existing

AquaLink

Loosen DO NOT REMOVE the two screws

securing the RS485 connector bracket in place.

Slide out and expose the 4 pin RS485 connection

terminal.

From an open auxiliary on your automation system

run the RS485 cable to the 4 pin RS485 connection

terminal.

Unscrew cable fi tting nut, pass RS485 wires

through and re secure nut.

Installation & Operation Manual

White

Red

White

Neutral

Wiring with a 120 VAC Filter Pump