Boost/Low Mode; Polarity Reversal - Zodiac Jandy Pro TruClear Manual De Instalación Y Funcionamiento

Jandy Pro Series TruClear
® ™
supplying to the pool. Another cause may be the lack of
Cyanuric Acid (CYA) at appropriate levels to protect the
chlorine from the UV rays of the sun.
NOTE
The unit only runs while your pump is running. More
pump runtime will result with more chlorine in the water.
With all the variables mentioned above, it may take you a
couple weeks to fi nd the right production rate for your pool.
To adjust the output level, follow these steps: To adjust the output level, follow these steps:
1. 1. Turn the power pack on by pressing the Turn the power pack on by pressing the
2. Press the buttons to reach the desired output
level. The minimum setting is 10%. The output can
be adjusted in increments of 10% up to 100%. This
controls the amount of run time for the cell.
Never use dry acid to adjust pH in arid geographic areas with excessive
evaporation and minimal dilution of pool water with fresh water. A build up of by
products can damage the electrolytic cell.
IMPORTANT Always test the chlorine levels of your pool before each use. During heavy
usage where bather load is increased, chlorine levels may deplete quickly and require
more adjustments. Monitor the chlorine closely, and take appropriate measures in
order to maintain the recommended 1 - 3 ppm free chlorine residual.
Figure 6. Total Hardness (United States)
|
Chlorine Generating System Installation & Operation Manual
CAUTION
5.6

BOOST/LOW Mode

The BOOST mode can be used to maximize chlorine
output for a short period of time. To activate BOOST
mode, press the
boost will turn off after 24 hours. To turn off BOOST
mode manually, press the
The LOW mode can be used to minimize chlorine output
while activated. To activate LOW mode, press the
buttons simultaneously. The LOW mode will stay on
button.
indefi nitely. To turn off LOW mode, press the
5.7

Polarity Reversal

The Jandy Pro Series chlorine generating device is a
reversible polarity cell which means that the cell will
ENGLISH
and buttons simultaneously. The
button.
periodically switch its polarity
to help prevent any build up of
calcium on the cell plates. This
is sometimes referred to as the
automated cell cleaning feature.
During the transition between
changing its polarity there is a
brief period when the cell will
not produce any chlorine. Once
it has changed polarity, it will
continue to make chlorine.
In areas of hard water (See map
in Figure 6). It is recommended
that you manually adjust the
polarity reversal time from
5 hours to three hours. To
make the change, press and
hold the up and down arrows
simultaneously to enter the
service mode. See Figure 6.
Press the right arrow key once
to select "Cyc=". Use the
button to cycle between three,
fi ve and seven hour cycles. Press
the button to exit.
NOTE
'CLEANING' will be
displayed on the screen during
the 'WAIT' period. The output level
indicator will remain as set during
the cleaning period.
Page 21
and
button