Adjusting Suction Power; Switching Off The Appliance And Retracting The Power Cord - Dirt Devil Galileo M8000 Manual De Instrucciones

3 Operation
NOTE:
Your vacuum cleaner has an integrated protection function that trips before the appliance can
overheat (e. g. due to blocked suction paths or an overfilled dust filter bag). If this protective func-
tion trips, the suction power will be strongly reduced. If this occurs, switch off the device, unplug
the plug from the socket and eliminate the cause of overheating. You can then turn the clean,
fully-assembled vacuum cleaner back on.
3.2 Adjusting suction
power
18
1
19
3.3 Switching off the appli-
ance and retracting the
power cord
20
1
38
You can adjust the suction power to suit the type of floor be-
ing cleaned.
1. Slide the suction power control to variably adjust the
suction power (Fig. 18/1):
- Low suction power ("min"):
For example for textiles, such as curtains and drapes
- High suction power ("max"):
For example for deep-pile carpets
NOTE:
The bypass vent (Fig. 19) must be completely closed for
vacuuming. With the bypass vent you can quickly reduce
the suction power, e.g. to release curtains that have acci-
dentally been sucked in.
1. Switch off the cylinder vacuum cleaner with the on/off
switch (Fig. 20/1) and unplug the plug from the mains
socket.
2. Keep the plug in your hand.
WARNING:
2
Danger of injury! During uncontrolled retraction, the
power cord can whip around, become a tripping hazard
or knock over objects. Therefore, keep the plug in your
hand and guide the cord when retracting it.
3. Push the cable retraction button (Fig. 20/2) to retract
the power cord.