Domo DO157A Manual De Instrucciones página 24

USE
Plug the power cord into a socket. A beep indicates that the device is in standby mode. You can control
the fan from the control panel or with the remote control. Each time a button is pressed, the device emits
an audible signal. The desired setting appears on the display.
ON/OFF BUTTON
Press this button to turn the device on or off. The latest configuration will be applied automatically when
the device is turned back on.
OSCILLATION BUTTON
Press the oscillation button to rotate the vertical air vent left to right in order to distribute the air. The
associated symbol
HUMIDIFIER/COOLER
Press the humidifier/cooler button to activate this function. The associated symbol
display. Make sure the water reservoir contains water before activating this function. The water pump
transports water to the honeycomb water filter in order to generate a cool air flow. Press this button
again to deactivate the function. In order to do this, follow the steps below.
1. Remove the water reservoir from the device (A). Fill the water reservoir with clean water. Make sure
you do not exceed the maximum level (see maximum indicator at the front of the device). Make sure
the pump is mounted correctly (B). Close the water reservoir (C).
A
2. Place the 2 refrigerating elements with water in the freezer until completely frozen. Attention: never
open the refrigerating elements to prevent potential damage.
3. Place 1 refrigerating element inside the water reservoir and close the water reservoir. The water
temperature will remain around 6°C lower than room temperature for around 4 hours, ensuring a
chilled air flow. Attention: make sure the maximum level of the water reservoir is not exceeded after
adding the refrigerating element.
4. Add the second refrigerating element to lower the temperature even further. The 2 refrigerating
elements are reusable. Alternatively, add ice cubes instead of the refrigerating elements, they will
have a chilling effect as well.
24
DO157A
appears on the display. Press this button again to deactivate the function.
/
B
appears on the
C