Epson TM-P80 Manual Del Usuario página 13

Ocultar thumbs Ver también para TM-P80:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
Belt Clip
You can hang the printer on your belt using the belt clip (L 16) attached to the back
of the printer.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
Remaining battery charge is not adequate
Roll paper end
Error
Troubleshooting
No lights on the control panel
Check that the battery is installed.
Error LED is flashing or on
The printer temperature may be too high. The printer resumes printing
automatically when the temperature returns to normal.
Make sure that the roll paper cover is properly closed.
Make sure that roll paper is installed.
When the printer power is on, if the Error LED is on and the Battery LED is
off, the remaining battery charge is not enough for printer operation. Replace
or charge the battery.
Turn off the power, wait several seconds, and then turn it on again. If the
error remains, contact a qualified service person.
The battery will not charge
When the battery is not fully charged even if charged for about 5 hours, the
battery is defective.
The battery must be replaced with a new one.
Turn on the printer, install the roll paper and close the roll paper cover.
After that if the Error LED is on and the Charge LED is flashing, the battery is
defective.
The battery must be replaced with a new one.
The Battery cover will not open
Follow the steps below when the Battery cover will not open.
1.
Make sure that the printer is turned off.
2.
Turn the lever to the
3.
Move the notch (M 17) in the direction of the arrow by using a tool such as a
ballpoint pen. See illustration M.
mark.
TM-P80 User's Manual 7
English

Publicidad

Tabla de contenido
loading

Tabla de contenido