Stihl MSE 170 C Manual De Instrucciones página 32

English
Flip the handle down.
N
Filler cap is now closed.
If the filler cap will not engage into the
tank housing
The base of the filler cap is rotated in
relation to the upper part.
Look at the black alignment marks
N
on the top of the filler cap.
30
1
Left: Base of filler cap is rotated to
the closed position – interior
marking (1) is aligned with
the exterior marking.
Right: Base of filler cap is in the cor-
rect position for installation –
interior marking is below the
clip. It does not align with the
exterior marking.
If your cap is in the closed position:
N
with the filler cap in the filling neck,
twist it counterclockwise until it
drops into its seat.
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position for
installation.
While pushing down on the cap,
N
twist the filler cap clockwise and
close it – see section "Closing."
Checking oil level
1
Check the oil level regularly during
N
operation.
Refill the oil tank when the oil level
N
reaches the "min" mark (1) or
earlier.
If the oil level in the tank does not go
down, the reason may be a problem in
the oil supply system: Check chain
lubrication, clean the oilways and
contact your dealer for assistance if
necessary. STIHL recommends that you
have servicing and repair work carried
out exclusively by an authorized STIHL
servicing dealer.
MSE 170 C, MSE 210 C