Stihl MSE 170 C Manual De Instrucciones página 9

Ocultar thumbs Ver también para MSE 170 C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
To reduce the risk of personal injury
from fire and explosion, do not use the
chain saw in the presence of flammable
liquids or gases. The sparks from an
electric chain saw may be a source of
ignition!
WARNING
Inspect the power cable
before and after each use
for signs of damage or
aging. In order to reduce
the risk of serious or fatal
injury from electrocution,
never use your chain saw
if the power cable is cut,
cracked, worn or dam-
aged. Turn off power at
chain saw, disconnect
the plug immediately and
have dealer replace such
a cable.
Avoid damage to the power cable. Keep
it away from heat, oil and sharp edges.
Never jerk power cable to disconnect the
plug from the wall outlet. To unplug,
grasp the plug, not the cable.
Always disconnect the plug when the
chain saw is not in use.
Extension Cords
WARNING
To reduce the risk of electric shock, use
only extension cords that are intended
for outdoor use. These extension cords
MSE 170 C, MSE 210 C
are identified by a marking "Acceptable
for use with outdoor appliances; store
indoors while not in use."
Do not use damaged extension cords.
Examine extension cord before using
and replace if damaged. Do not abuse
extension cord and do not yank on any
cord to disconnect.
If you use an extension cord, be sure to
use one heavy enough to carry the
current your electric saw will draw. An
improper gauged extension cord will
cause a drop in wire voltage resulting in
loss of power and overheating. Use only
extension cords having an electrical
rating not less than the rating of the
product.
The following table shows the correct
size to use depending on cord length
and machine label ampere rating.
Minimum Wire Size for Extension Cords
for 120 Volt Appliances
Cord types: SJW-A or SJTW-A
Round jacketed cords
Using not more than 12 amps
Cord length (ft)
50
100
Wire size (AWG) 16
14
Using not more than 15 amps
Cord length (ft)
50
100
1)
Wire size (AWG) 12
1)
not recommended
Listed by UL, W-A marking on cable
jacket indicates "use outdoors".
Appropriate extension cords are
available in stores spezializing in
electrical equipment.
To reduce the risk of electric shock, this
equipment has a polarized plug (one
blade is wider than the other).This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper outlet. Do not change the
plug in any way.
WARNING
Position the electric cable so that it will
not be damaged when using the electric
saw. Always keep the electric cable
behind the operator and away from the
bar and chain. Always be sure that your
cable does not become entangled with
obstacles or objects. Damaged cables
may cause electrocution. If you take a
break at your work, always disconnect
the cable.
Holding and Controlling the Chain Saw
Always hold the chain saw firmly with
both hands when you are working. Place
your left hand on the front handle bar
and your right hand on the rear handle.
150
12
150
1)
Left-handers should follow these
instructions too. Wrap your fingers
tightly around the handles, keeping the
handles cradled between your thumb
and forefinger. With your hands in this
position, you can best oppose and
English
7

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Mse 210 c

Tabla de contenido