Stihl MSE 170 C Manual De Instrucciones página 40

English
STIHL saw chains are sharpened to a
filing angle of 30°. Exceptions are
ripping chains with a filing angle of 10°.
Ripping chains have an X in their
designations.
B Side plate angle
The correct side plate angle is obtained
automatically if you use the prescribed
file holder and file diameter.
Cutter shapes
Micro = semi chisel cutter,
e.g. 63 PM3, 26 RM3,
36 RM
Super = chisel cutter, e.g.
63 PS3, 26 RS, 36 RS3
Ripping chain, e.g.
63 PMX, 36 RMX
The angles must be the same on all
cutters. If the angles are uneven: Chain
will run roughly, not in a straight line,
wear quickly and finally break.
File holder
Use a file holder
N
A file holder must be used for manual
resharpening (see table "Sharpening
Tools"). The correct filing angles are
marked on the file holder.
38
Use only special saw chain sharpening
files. Other files have the wrong shape
and cut.
For checking angles
Angle (°)
A B
30 75
Use a STlHL filing gauge (special
30 60
accessory, see table "Sharpening
Tools"). This is a universal tool for
10 75
checking the filing and side plate angles,
depth gauge setting, cutter length and
groove depth. It also cleans the guide
bar groove and oil inlet holes.
File correctly
Disconnect the plug from the wall
N
outlet.
Select sharpening tools according
N
to chain pitch.
Clamp the bar in a vise if necessary.
N
To rotate the chain – pull hand
N
guard against handle to disengage
the chain brake Hold the hand guard
in this position – the coasting brake
is disengaged.
Sharpen the chain frequently, take
N
away as little metal as possible –
two or three strokes of the file are
usually enough.
Hold the file horizontally (at a right
N
angle to the side of the guide bar)
and file according to the angles
marked on the file holder. Rest the
file holder on the top plate and depth
gauge.
Always file from the inside to the
N
outside of the cutter.
The file only sharpens on the
N
forward stroke – lift the file off the
cutter on the backstroke.
Avoid touching the tie straps and
N
drive links with the file.
Rotate the file at regular intervals
N
while filing to avoid one-sided wear.
Use a piece of hardwood to remove
N
burrs from the cutting edge.
Check angles with the filing gauge.
N
All cutters must be the same length.
MSE 170 C, MSE 210 C
90°