Ordering Spare Parts - Stihl MSE 170 C Manual De Instrucciones

English
Cutting Attachments
Recommended cutting attachments
conforming with the 45 degree
computed kickback angle requirement
of Section 19.108 of UL 60745-2-13
when used on this model chain saw (see
the chapter on "Safety Precautions and
Working Techniques"):
Rollomatic E guide bars
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30, 35, 40 cm (12, 14,
16 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.3 mm (0.050 in)
Sprocket nose: 9-tooth
Actual cutting length will be less than
listed bar length.
Saw chain 3/8" P
Low kickback STIHL saw chain (with
green label)
Picco Micro 3 (63 PM3) Type 3636
Picco Duro 3 (63 PD3) Type 3612
Pitch: 3/8" (9.32 mm)
Drive link gauge: 1.3 mm (0.050 in)
Chain sprocket
7-tooth for 3/8" P(spur sprocket)
To comply with the 45 degree computed
kickback angle requirement of Section
19.108 of UL 60745-2-13 (and Section
5.11 of ANSI/OPEI B175.1-2012), use
replacement saw chains listed above or
elsewhere by STIHL as conforming with
those requirements when used on this
model chain saw or use saw chains
44
classified as "low kickback" in
accordance with
ANSI/OPEI B175.1-2012.
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.

Ordering Spare Parts

Please enter your saw model, serial
number as well as the part numbers of
the guide bar and saw chain in the
spaces provided. This will make re-
ordering simpler.
The guide bar and saw chain are subject
to normal wear and tear. When
purchasing these parts, always quote
the saw model, the part numbers and
names of the parts.
Model
Serial number
Guide bar part number
Chain part number
See "Specifications" in this manual for
the recommended reduced kickback
cutting attachments.
MSE 170 C, MSE 210 C