Installation; Unpacking - Fri-Jado STG 5-i Instrucciones De Manejo

3.

Installation

WARNING
Have an authorised installer position and install the unit.
3.1.

Unpacking

1. Check the contents and the volume of the delivery. Contact the dealer if the contents are incomplete.
The contents include the following parts:
• Oven
• User manual and CE declaration
• 6 fine-meshed baking racks
2. Remove all parts from the unit.
3. Remove all packaging materials from the unit.
4. Remove the foil from all metal parts.
5. Inspect the unit and the parts for damage.
6. Carefully read the whole manual before proceeding.
3.2. Installation
WARNING
• Use suitable hoisting, lifting and transport devices for handling the unit.
• Put the brake unto the wheels of the unit or the base when the unit is on the right place.
• Make sure there is a clearance of at least 100 mm between the sides and other equipment or
walls.
• Make sure there is a clearance of at least 100 mm between the back and other equipment or
walls.
• Make sure there is a clearance of at least 500 mm above the oven.
• Do not place racks with hot products against the side walls of the oven or on top of the
oven.
• Position the unit flatly on a sufficiently sturdy base using a spirit level. Take the weight of
the unit into account.
• The opening between the unit and the table surface must be free from obstacles to ensure
good ventilation in the electrical compartment.
WARNING
Have an authorised installer install the wall socket.
Follow the procedure below when storing a unit that will not be used for some time:
• Thoroughly clean the unit.
• Package the unit dustproof.
• Store the unit in a dry place.
Find a suitable place for the unit. Points of interest:
• The surface has to be level. The surface must be able to bear the weight of the unit.
• Keep 750 mm free space on the front side of the oven for unloading products.
• Make sure there is sufficient room to operate and maintain the unit.
WWW.FRIJADO.COM 2-EN-11
STG 5 / 7 / 8 - I
9123494 - 4/2009