Original Operating Manual; Technical Data; Intended Use; General Safety Instructions - Festool LEX 2 185/7 Manual De Instrucciones

LEX 2
GB

Original operating manual

1

Technical data

Compressed air eccentric
sander
Sanding pad diameter
Drive
Operating pressure (flow
pressure)
Speed
Working strokes
Sanding stroke
Air consumption at nominal
load
Weight
2 Symbols
Warning of general danger
Manual, read the instructions
Wear ear protection.
Wear protective goggles.
Wear a dust mask.
Do not throw in the household waste.
The specified illustrations appear at the beginning
of the Operating Instructions.
3

Intended use

The compressed air eccentric sanders are suitable
for sanding wood, plastic, metal, stone, compos-
ites, acrylic-based mineral materials, paint/clear
coats, fillers and similar materials.
Materials containing asbestos must not be pro-
cessed.
12
LEX 2 185/7
185 mm
Compressed-air
vane motor
6 bar
6500 - 8000 rpm
13000 - 16000 rpm
7 mm
390 l/min
1,4 kg
The user is liable for improper or non-in-
tended use.
4 Safety instructions
4.1

General safety instructions

General safety regulations
Warning! Before setting up, using, repairing
and servicing this compressed air tool or re-
placing accessory parts, you must have read and
understood all safety instructions and informa-
tion. Ignoring warning notes and instructions may
result in serious injuries.
– Only trained and qualified persons are permitted
to set up, adjust and operate this compressed air
tool. Persons without the relevant qualifications
and training are more likely to cause accidents.
– This compressed air tool may not be modified.
Modifications may reduce the effectiveness of
safety devices and pose a greater risk to operat-
ing personnel.
– Keep all of the attached documents and pass on
the documentation if the machine changes own-
ership.
– Never use a damaged compressed air tool.
– Regularly inspect compressed air tool. The com-
pressed air tool must be marked with clearly leg-
ible rated values and markings. Replacement
signs can be ordered from the manufacturer.
Danger from ejected parts
– In the event the workpiece, accessory or machine
parts break parts may be ejected at high speed.
– Wear impact-resistant protective goggles.
– Wear a helmet when doing overhead work. Also
assess the risks for other people.
– Secure the workpiece. Use clamping devices or a
vice to hold the workpiece firmly.
Risk of getting caught
– Wear suitable protective clothing! Do not wear
loose clothing or jewellery. They can be caught by
moving parts. Wear a hair net if you have long
hair.