Assembly And Installation - S&P HTB-2500 Manual De Instalacion Y Uso

• The large-diameter HTB models are class I devices, so the grounding cable in the per-
manent installation must be connected to the device.
• Before connecting the device to the power grid, make sure the power is switched off and
has the specifi cations listed on the fan plate.
• If you are going to install more than one fan, make sure you don't use the blades from one
fan on another, even if they are the same model. The blades are carefully weighed and
grouped into batches of 8 units at the factory.
• Each fan is controlled by an electronic control box. The same control box can't be used for
more than one fan.
• Children aged 8 and up can use this fan, as can individuals with physical, sensory or mental
disabilities when supervised or properly trained to use the device safely and made aware of
the dangers that may be involved.
• Children should not be allowed to play with the device.
• User cleaning and maintenance should not be done by unsupervised children.
• Before doing any cleaning on the outside of the fan, make sure the power is switched off
at the mains.
• When installing, cleaning or carrying out maintenance, don't lean on the blades.
• When carrying out maintenance, check the ceiling anchors/structure to make sure they
haven't come loose over time.
• Never put anything into the blades of the fan while it is on. This could damage the device
and its anchors, which could cause it to fall.

4. ASSEMBLY AND INSTALLATION

Main parts:
1. Motor body.
2. Support pole.
3. Aluminium blades (x 8), length depending on model purchased)
4. Screws to attach blades x 24/ 32 (quantity depending on model purchased).
5. Cap nuts to attach blades x 24/ 32 (quantity depending on model purchased).
6. Safety washers to attach blades x 24/ 32 (quantity depending on model purchased).
7. Metal ceiling bracket.
8. Metal anchors (x 5)
9. Control box.
10. Remote control (2 x AAA battery).
11. Wall bracket for remote control.
12. Installation and Instruction Manual.
Follow the steps below to assemble and install the device:
Note: Given its size and weight, don't assemble the blades on the fan until it is properly insta-
lled and hung. Follow the assembly steps in the order given below:
14