Unpacking Instructions; Installation Instruction - S&P HTB-75 RC Manual De Instrucciones

IMPORTANT NOTE : The warnings,safeguards and instructions given in this manual are not
exhaustive and do not nessecarily cover all eventualities. It must be understood that common sense,
caution and care are factors which cannot be built into any product. These factors must be supplied
by the person(s) caring for and operating the unit.

UNPACKING INSTRUCTIONS

Before assembling the ceiling fan, remove all parts from the shipping carton and check them
against the parts listed below (Fig. 1):
Support plate (1 pc.)
Motor assembly and support (1 pc.)
Blades (3 pcs.)
Blade fitting screw (6 pcs.)
Washers (6 pcs.)
Speed regulator (1 pc.)
Wall plugs (2 pcs.)
Screws (2 pcs.)
Washers ( 2 pcs.)
Felt washers ( 3pcs )
Instructions Manual

INSTALLATION INSTRUCTION

FITTING THE FAN TO THE CEILING
Important: To avoid the possibility of accidents caused by the fan, which could imply legal
responsibilities for the installer, compliance with each of the following instructions is essential.
Ensure that the distance between the lowest point of the fan, once installed, and the floor is at
least 2.3 .
Check that the means of fitting the fan to the ceiling is capable of supporting the weight of the fan
when in operation.
HTB-75 RC / 90 RC minimum 25 Kg.
HTB-140 RC / 150 RC minimum 40 Kg.
To ensure correct installation, drill four holes of the same diameter as the wall plugs (G) in the con-
crete ceiling. Insert the plugs supplied and fix the support plate (A) using the four screws (H) and
washers (I) provided. (Fig. 2)
Fitting to a false ceiling
Make a hole in the false ceiling that is large enough to allow the introduction of a rigid, wooden or
metal cross beam. This should be as long as possible and under no circumstances less than 25cm.
in length, to allow the best distribution of the weight of the fan.
Without reducing its ability to support the fan, make a small groove at the centre of the crossbeam,
then locate the beam so that its centre coincides with the hole in the ceiling.
Join the support plate (A) to the crossbeam using galvanised metal wire of at least 2.5mm in diameter.
Passing the wire through the grooves in the plate, wind it around the crossbeam and back through
11