Unpacking Instructions; Installation Instruction - S&P HTD-130 MR Manual De Instalacion E Instrucciones De Uso

UNPACKING INSTRUCTIONS

Before assembling the ceiling fan, remove all parts from the shipping carton and check them
against the parts listed below (fig. 1 ) :
MODEL A B C
HTL-130 1G 1 1 1
HTL-130 4F 1 1 1
HTD-130MR 1 1 1
HTD-130 B 1 1 1
A- Hanging plate
B- Upper Canopy
C- Support downrod
D- Cotter pin safety dowel
E- Cotter pin
F- Motor
G- Switch housing assembly
H- Switch housing
I- Washers
J- Screws
K- Blade brackets
L- Blades
M- Washers
N- Screws
O- Washers
P- Screws
Q- Screws
R- Washers
S- Wall plugs
T- Blade fixing bracket
Balancing kit
Instructions Manual

INSTALLATION INSTRUCTION

FITTING THE FAN TO THE CEILING
Important: To avoid the possibility of accidents cause by the fan, which could imply legal
responsibilities for the installer, compliance with each of the following instructions is essential.
Ensure that the distance between the lowest point of the fan, once installed, and the floor is at
least 2.3 metres.
Check that the means of fitting the fan to the ceiling is capable of supporting the weight of the
fan when in operation. (Minimum 25 Kg.).
Fitting to a concrete ceiling
To ensure correct installation, drill four holes of the same diameter as the wall plugs (S) in the
concrete ceiling. Insert the plugs supplied and fix the support plate (A) using the four screws (P)
and washers (O) provided. (Fig.2).
D E F G H I
1 1 1 1 2 10 10
1 1 1 1 2 10 10
1 1 1 1 1 8
1 1 1 1 1 8
J K L M N O
5 5 - 15 4
5 5 15 15 4
8 4 4 12 12 4
8 4 4 12 12 4
14
P Q R S T LAMP
4 4 4 4 5 KIT 1
4 4 4 4 - KIT 4
4 4 4 4 -
4 4 4 4 -
-
-