HSM SECURIO AF100 Instrucciones De Servicio página 16

english
6 Troubleshooting
Problem Remedy
The cutting
 Paper jam in the auto-feed stack.
unit runs
Cause: Paper clips or staples in the paper stack.
for approx.
• Remove the paper clips or staples from the paper, and load the stack again.
5 seconds
without pull-
ing in paper
from the
stack.
Paper jam  The cutting unit runs in reverse for a few seconds and pushes the paper
back out again.
Cause: You have fed in too much paper at once.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed in the paper in sheet at a time.
Note:
If the majority of the paper stack has already been drawn in before the blockage
occurred, you can also press the reverse button "R" for longer than 5 seconds.
This makes the cutting unit run forwards again and shred the remaining paper.
Cutting unit is  Paper jam in the auto-feed stack
not working.
• For troubleshooting see above.
 Incorrect cutting head position
• Place the cutting head in the correct position on the container
for shredded material.
 Full shredded material container
• Empty the shredded material container.
CAUTION
since cutting unit malfunctions can occur from repeated pressing of
the shredding material.
 The motor was overloaded.
• Let the shredder cool down for 20 minutes before starting it up again.
16
Empty the full shredded material container immediately,
SECURIO AF 100
04/2018